Same-day and emergency service (816) 555-0142

Tree root removal

Tree Root Removal from Sewer Lines

Roots do not break into a healthy pipe. They find the small leaks that were already there. Here is how roots get in, how they are cleared and how to keep them from coming back.

If a sewer line in the Kansas City area keeps backing up, roots are the first suspect. The region has deep clay soil, many mature trees and a lot of housing from the decades when sewer laterals were made of clay tile or cast iron. That combination is a steady source of root problems, and it is one of the main reasons people call for a jetting.

This page explains how roots get into a sewer line, how to recognize them, how they are removed and what a realistic maintenance plan looks like.

How roots get into a pipe

A tree root grows toward moisture and nutrients. A sewer line is warm, wet and full of both. A pipe that is sound and tightly sealed gives the root nothing to grab. A pipe with a joint that has shifted, a hairline crack or an old mortar seal that has failed lets a small amount of moisture and vapor escape, and the root follows that signal.

Once a fine root hair gets through, it grows in the water flow and thickens. Over months or a few years it turns into a mat that stretches across the pipe and snags paper and waste. The pipe is not usually damaged by the root itself at first. The clog is.

Over longer periods, large roots can widen a gap, push a joint further out of line or add pressure that breaks the pipe. That is when a cleaning is no longer enough.

Why the Kansas City area sees so much of it

Clay tile and cast iron laterals. Many houses built through the 1950s and into the 1960s and 70s have clay tile sewer pipe in short sections. Each joint is a place a root can enter. Cast iron joints sealed with oakum and lead can also leak after decades.

Mature trees. Silver maple, sycamore and elm are among the species that send out aggressive, water-seeking roots, and they are common in older neighborhoods around Kansas City, Prairie Village, Shawnee, Raytown and Grandview. A tree does not have to be close to the house. Roots travel well past the canopy.

Clay soil. Soil that swells when wet and shrinks when dry moves, and that movement works joints loose over time.

Lawn irrigation. Regular watering nearby draws roots toward the same area.

Newer areas are not immune. Plastic pipe with tight rubber-gasket joints is more resistant. But trees planted near a lateral, or a joint that was poorly seated, can still get roots in.

Signs of roots in a sewer line

  • Slow drainage that comes and goes, often worse after a long period without much water use.
  • A gurgling toilet or a floor drain that bubbles when the washer drains.
  • A line that backs up every year or two, in the same pattern.
  • A backup that follows a dry spell or a wet spell.
  • A tree larger than the house within the yard, especially over the sewer line path.
  • A camera shows roots at joints, as threads or a dense mat.

Roots are only one cause of those symptoms, so a camera is the way to confirm. See sewer camera inspection.

How roots are removed

There are three main methods, and a technician may use more than one.

Cable with a cutting head. A cable machine with a blade or a chain cutter spins inside the pipe and cuts roots away from the walls. It is a standard method for opening a line fast. The downside is that it leaves stubs, and roots regrow from them quickly. A cable is often the right first step to restore flow.

Hydro jetting with a root cutting nozzle. A jetter fitted with a rotating nozzle or a chain flail clears roots and then flushes the cuttings out of the line. Because it cleans the wall, it removes more of the root mass and leaves a cleaner pipe. See hydro jetting for how that works. Jetting is not a replacement for a cable in every case, and a line with heavy roots often takes both.

Chemical root treatment. Foaming root inhibitors applied by a professional can slow regrowth in some lines. They do not remove roots already there, and they are not a substitute for cleaning. Whether they are appropriate depends on the line, local rules and the situation, so ask what a product contains and whether it is allowed where you live. We mention it because people ask, not because it is a solution by itself.

What cutting roots does and does not do

Cutting and jetting open the line and remove the roots that are in it. They do not stop the tree from growing, and they do not fix the opening that let the roots in. The root will come back, and the speed depends on the tree, the soil moisture and the size of the gap. In a line with a small number of fine roots, a cleaning can last years. In a line with an active large tree and an open joint, it may need doing every year.

The permanent fix for a damaged pipe is repair or replacement. A section can be replaced by digging, or in some cases lined from the inside without full excavation. A camera shows whether the pipe is a candidate. That is a separate project from cleaning, and we will tell you when we think the line is past what cleaning can do.

Maintenance intervals

There is no universal schedule. These are general starting points.

  • A line with no known root history: no schedule. Have it looked at if there are symptoms.
  • A line with light roots, cleaned once: recheck in two to three years, or sooner if symptoms return.
  • A line with moderate roots and a large tree nearby: clean every one to two years.
  • A line with heavy roots and a known open joint: every six to twelve months until it is repaired, or consider repair.

The best way to set the interval is to clean the line, look with a camera and then watch how fast it fills. If the same problem comes back in eight months, the interval is eight months, minus a safety margin.

Rental property and commercial owners should schedule rather than wait, because a backup in a tenant's unit costs far more than the cleaning.

What to do about the tree

Removing a tree is a big decision, and it does not always fix the pipe. Roots can stay alive in the pipe for some time, and removing a large tree can change soil moisture. Talk to an arborist before making that call. If you are planting new trees, keep them well away from the sewer lateral and favor species with less aggressive roots; a local nursery or the city forestry office can recommend options.

Who pays and who is responsible

In most of the metro the property owner is responsible for the private sewer lateral up to the public main. If roots are in the public main, that is the city's or the utility's responsibility, and a camera can show where the roots are. Check with the city or utility if you suspect the public main.

What a visit looks like

You call and describe the pattern: how often it backs up, where the trees are and where the cleanout is. The technician looks at access, runs a camera if the line is a candidate and then cuts and flushes the roots with the appropriate tool. Water is run to confirm flow, and the technician shows you what the camera found and discusses the interval.

Pricing depends on the line and the amount of roots. We do not post prices. Call for a quote.

We serve Prairie Village, Kansas City, MO, Shawnee, Raytown and the other cities on the service areas page.

Keeping records helps

Keep the camera recording and the date of each cleaning. When roots return, the interval between visits tells you how fast they are growing, and the recording shows whether the pipe is changing. If you sell the house, a history of maintenance and a clear recent recording is a reassurance for the next owner, and it shows that the line has been looked after.

How it works

From your call to a draining line

  1. 1

    Call and describe it

    Tell us which drains are slow or backed up, how long it has been going on and whether it is a house or a business. We give you the soonest arrival window we have.

  2. 2

    Look before cutting

    We check the cleanout and the fixtures, and run a camera down the line when the clog is deep or keeps coming back, so the plan fits the pipe.

  3. 3

    Pick the right tool

    A cable for a simple local clog, a jetter for grease, scale and roots. We explain why before we start.

  4. 4

    Clear and flush

    The line is cleared and rinsed so the pipe wall is open, not just a small channel through the blockage.

  5. 5

    Test and explain

    We run water to confirm it drains, show you what we found and tell you honestly whether it is likely to come back.

FAQ

Tree Root Removal questions

Can roots really get into a sewer pipe?

Yes, when there is a joint that has shifted or a crack that lets moisture escape. A sound, sealed pipe usually keeps them out.

Will roots come back after cleaning?

They can. How fast depends on the tree and the gap in the pipe. A maintenance schedule is the usual answer.

Does a tree need to be removed to fix the problem?

Not always. Cleaning and, if needed, repairing the pipe is the first step. Removing a tree is a larger decision that is not guaranteed to solve it.

Will jetting damage my pipe?

On a sound pipe, no. On a cracked or deteriorated pipe, it needs care and sometimes should not be done. That is why a camera comes first.

How can I tell if the roots are in my line or the city's?

A camera finds the location. If the roots are past the property line or in the main in the street, the public utility is responsible. A technician can tell you what the video shows.

How long does root removal take?

A light cleaning may take an hour or two. A line with a dense root mass, or one that needs both a cable and a jetter, can take longer.

Service area

Serving the south Kansas City metro

Drain cleaning and hydro jetting across Kansas City, Missouri and the Johnson County, Kansas suburbs, dispatched to your address when you call.

See all service areas

Tree Root Removal: call (816) 555-0142

Same-day and emergency service across the south Kansas City metro. Call for a quote.

Call nowMessage us